 |
| AegisGuard™ Wired Headset Radiation Shields - The Necessary Accessory™ Installation Instructions |
 |
| Please follow these instructions carefully to ensure successful installation of your AegisGuard™ Headset Radiation Shield (headset not included). Please contact us if assistance or additional information is required. |
| AegisGuard™ Headset Wire Shield Installation 1. Remove shield from card, then remove and discard glue backing. 2. Position headset wire just above the plug into either 'V' Channel. 3. Close one side over the other, verifying the wire passes through the opening on both sides and the side tabs lock. 4. To transfer to another headset, carefully open the side tabs using a small screwdriver. |   |
| AegisGuard™ Earpiece Shield Installation 1. Remove and discard the outer foam cover if your earpiece has one. 2. Remove the EarGel if your earpiece has one and reinstall it over the Earpiece Shield after completing installation 3. Stretch slightly with the front facing you and place part of the inside back edge over the earpiece. Hold both parts while continuing to work your way around the entire earpiece until completed. 4. Replace when outer foam surface begins to wear out. | 
|
| Corporate names, trademarks or registered trademarks on this page are the properties of their respective companies. |
| Copyright © 2008 Aegis Corporation All Rights Reserved |
